Yamaha TF3
€ 3.892
GLS - Pick-up-point | €0 |
GLS - Home Delivery | €10 |
GLS - Company Delivery | €10 |
Matching accessories:
- Plenty of inputs
- Hands-on control for most situations
- Lots of options in one compact console
Yamaha TF3
- 25 motorized faders (24 channel faders + 1 master)
- 48 mix inputs (40 mono + 2 stereo + 2 return)
- 20 Aux (8 mono + 6 stereo) + Stereo + Sub buses
- 8 DCA groups with roll-out
- 24 analog XLR/TRS combo mic/line inputs + 2 analog stereo phono line inputs
- 16 analog XLR outputs
- 34 x 34 channels digital input and playback via USB 2.0 + 2 x 2 via USB stick
- 1 expansion slot for NY64-D audio interface card
Model/Product no.: | YAM-TF3 |
GTIN | 4957812560313 |
Weight (kg) | 17 |
Specifications
Outline
Fader Configuration | 24 + 1 (Master) | |
---|---|---|
Mixing Capacity | Input Channels | 48 (40 mono + 2 stereo + 2 return) |
Aux Buses | 20 (8 mono + 6 stereo) | |
Stereo Buses | 1 | |
Sub Buses | 1 | |
Input channel functions | 8 DCA groups | |
I/O | Inputs | 24 mic/line (XLR/TRS combo) + 2 stereo line (phono) |
Outputs | 16 (XLR) | |
Expansion slots | 1 | |
On-board processors | DSP | 8 effects + 10 GEQ |
USB | 34x34 USB Audio Interface, 2-track recording to USB stick |
General specifications
Sampling frequency rate | Internal | 48 kHz |
---|---|---|
Signal delay | Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz | |
Fader | 100 mm motorized, resolution = 10-bit, +10 dB to -138 dB, - dB all faders | |
Total harmonic distortion | Less than 0.05% 20 Hz-20 kHz @+4 dBu into 600 ohms, INPUT to OMNI OUT, Input Gain=Min. (Measured with a -18 dB/octave filter@80 kHz) | |
Frequency response | +0.5, -1.5 dB 20 Hz-20 kHz, at +4 dBu output @1kHz, INPUT to OMNI OUT | |
Dynamic range | 110 dB typ., DA-converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min. | |
Hum & noise level | Equivalent input noise | -128 dBu typ., Input Gain=Max. (Measured with A-weighting filter) |
Residual output noise | -85 dBu, ST master off (Measured with A-weighting filter) | |
Crosstalk | -100 dB (Measured with a -30 dB/octave filter@22 kHz), consecutive INPUT/OMNI OUT channels, Input Gain=Min. | |
Power requirements | 100-240 V 50/60 Hz | |
Power consumption | 110 W | |
Dimensions | W | 716 mm (28.2in) |
H | 225 mm (8.9in) | |
D | 599 mm (23.6in) |
General specifications
Net weight | 17.0 kg (37.5lb) |
---|
General specifications
Accessories | Quick Guide, Power cable, CUBASE AI download information | |
---|---|---|
Options | Expansion card, foot pedal (FC5) | |
Others | Working temperature: 0-40 °C, Storage temperature: -20-60 °C |
Analog input characteristics
Input Terminals | GAIN | Load Impedance |
For Use With Nominal |
Input Level | Connector | balanced / Unbalanced |
||
---|---|---|---|---|---|---|---|---|
Sensitivity*1 | Nominal | Max. before clip | ||||||
INPUT1-24 | +66dB | 7.5K | 50-600 Mics or 600 Lines |
-82dBu (61.6 V) | -62dBu (0.616mV) | -42dBu (6.16mV) | Combo Jack (XLR-3-31 type *2 or TRS phone *3) |
Balanced |
-6dB | -10dBu (245mV) | +10dBu (2.45V) | +30dBu (24.5V) | |||||
ST IN 1,2 | - | 10k | 600 Lines | -30dBV (31.6 V) | -10dBV (316mV) | +10dBV (3.16V) | RCA Pin Jack | Unbalanced |
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
Output Terminals | Source Impedance |
For Use With Nominal |
GAIN SW | Output Level | Connector | balanced / Unbalanced |
|
---|---|---|---|---|---|---|---|
Nominal | Max. before clip | ||||||
OMNI OUT 1-16 | 75 | 600 Lines | "+24dBu" position (default) |
+4dBu (1.23 V) | +24dBu (12.3 V) | XLR-3-32 type *1 | Balanced |
PHONES *3 | 100 | 40 Phones | - | 3mW | 75mW | Stereo Phone Jack (TRS) *2 | Unbalanced |
*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.
Digital input/output specifications
Terminals | Format | Data length | Audio | Connector |
---|---|---|---|---|
USB (TO HOST) | USB | 24bit | 34ch input / 34ch output, PCM | USB (B type) |
iPad | USB | - | Playback: MP3 or WAV file data / Record: WAV file data | USB (A type) |
Control I/O specifications
Terminals | Format | Level | Connector |
---|---|---|---|
NETWORK | IEEE802.3 | 10BASE-T/100Base-TX | RJ-45 |
FOOT SW | - | - | TS Phone |